Digital electronic truck scale in the rainy day how to do bubble water?

Digital electronic truck scale in the rainy day how to do bubble water?

The daily use of digital electronic truck scale is more afraid of lightning strike and bubble water, but in case of digital electronic truck scale bubble water how to do?

First, check the junction box. If the junction box is flooded, all the signals of the weighing sensor are sent out by the junction box. And the circuit inside the junction box is short-circuit due to water, then the signals sent out must be unstable. The treatment methods used are:

Remove the junction box, dry the water in the junction box with a hair dryer, and try again to see if it weighs properly. If it still doesn't work, the junction box needs to be replaced.

2. The four corners of the weighing sensor of digital electronic truck scale will be too large when it is flooded. If the electronic weighing sensor is net soaked in water for a long time, the internal circuit of the weighing sensor may be damaged, resulting in too many weighing errors; The solution is:

Measure the weighing sensor on one side with a multimeter to see which weighing sensor has been damaged. Generally speaking, the cost of repairing the weighing sensor is relatively high, and the repair time is also relatively long, so it is more appropriate to consider direct replacement.

3. The external environment for the electronic scale load sensor formation is mainly the following aspects, the influence of the high corrosive environment, such as moisture, acid formation of sensor elastomer, damaged or short circuit, so if the digital electronic truck scale, environment is poor, should choose the shell made plastic or stainless steel shell junction box, good corrosion resistance and impermeability.